LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Charging System - 2.0L (Except HEV)) >> Alternator >> Repair Procedures >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the cooling fan.

    (Refer to Engine Mechanical System - "COOLING FAN ")

  3. Disconnect the A/C compressor switch connector (A) the alternator connector (B), and the cable from alternator "B" terminal (C).
    Fig 1: Disconnecting A/C Compressor Switch Connector And Alternator Connector
    G11994162Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the drive belt (A) after turning the drive belt tensioner (B) counterclockwise.
    Fig 2: Removing Drive Belt
    G11994163Courtesy of HYUNDAI MOTOR AMERICA
  5. Pull out the through bolt and then remove the alternator (A).

    Tightening torque: 

    49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

    Fig 3: Removing Alternator
    G11994164Courtesy of HYUNDAI MOTOR AMERICA
  6. Installation is the reverse order of removal.
scientia non olet · About LEMON Manuals