Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the alternator cover (A) using a screw driver after loosening the nuts (B).

Fig 1: Removing Alternator Cover
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting bolts (A) and disconnect the brush holder assembly (B).

Fig 2: Disconnecting Brush Holder Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the nut, pulley (A) and spacer.

Fig 3: Removing Nut, Pulley And Spacer
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the 4 through bolts (A).

Fig 4: Loosening Through Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the rotor (A) and cover (B).

Fig 5: Disconnecting Rotor And Cover
Courtesy of HYUNDAI MOTOR AMERICA
Reassembly is the reverse order of disassembly.