Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
- Battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
- Remove the drain plug (A) and drain the ATF totally and then reinstall the drain plug.
Tightening torque:
33.3 ~ 43.1 N.m (3.4 ~ 4.4 kgf.m, 24.6 ~ 31.8 lb-ft)
CAUTION:- Replace the gasket before reinstalling the drain plug.
- After the installation, start the engine and then check if there are any leakages from the drain plug.
- Remove the wiring mounting bolt (A) or clip.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
- Disconnect the air breather hose (A) from the valve body cover.
- Remove the valve body cover (A).
Tightening torque:
11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)
CAUTION:- Replace the gasket (B) before reinstalling the valve body cover.
- After the installation, start the engine and then check if there are any leakages from the valve body cover.
- Disconnect the oil temperature sensor (A) and solenoid valve connector (B) from the valve body.
Tightening torque
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:- Check for the looseness, poor connection, bending, corrosion, contamination, deterioration, or damage before reinstalling the solenoid valve connector.
- Remove the valve body assembly (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
NOTE:- Reassembly and disassembly procedures of the valve body assembly, refer to overhaul service information.