Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION:

If the oil seal on the transaxle case side is damaged and fluid is leaking, replace the oil seal with a new unit. When installing the new oil seal, use the specialized tool (Oil seal installer SST No.: 09453-3L240, Bar SST No.: 09231-H1100).

Install in the reverse order of removal.
NOTE:
Perform the procedures below after replacing the oil pump.
- Check fluid level after filling the automatic transaxle with fluid.
  (Refer to Hydraulic System - "FLUID ")
- Perform the TCM adaptive values learning procedure.
  (Refer to Automatic Transaxle Control System - "REPAIR PROCEDURES ")
- Start the engine and then check if there are any leakages from the transaxle case.