Repair Procedures: Replacement
WARNING: This page is about a different variant/trim than selected.
NOTE:
ATF of 6 speed automatic transaxle doesn't be replaced. But, if the vehicle is severe use or business use, replace ATF every 60, 000 miles for severe usage. Severe usage is defined as
- Driving in rough road (Bumpy, Gravel, Snowy, Unpaved road, etc)
- Driving in mountain road, ascent/descent
- Repetition of short distance driving
- More than 50% operation in heavy city traffic during hot weather above 32°C (89.6°F).
- Police, Taxi, Commercial type operation or trailer towing, etc
- Lift the vehicle, then remove the under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
- Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.CAUTION:
- Replace the gasket before reinstalling the drain plug.
Drain plug tightening torque:
33.3 ~ 43.1 N.m (3.4 ~ 4.4 kgf.m, 24.6 ~ 31.8 lb-ft)
- Put down the vehicle with the lift and then remove the eyebolt (A).
- Fill the ATF about 5 liters to the injection hole.
- Check the ATF level.
(Refer to Hydraulic System - "FLUID ")
- Then finish check the ATF level procedure and install the under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
- Put down the vehicle with the lift and then tighten the eyebolt.
Eyebolt tightening torque:
4.9 ~ 5.9 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)
CAUTION:- Replace the gasket (A) before reinstalling the eyebolt.