Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install the new gasket and water pump (A).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 1: Locating Gasket And Water Pump
Courtesy of HYUNDAI MOTOR AMERICA
Install the water pump pulley (A).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 2: Locating Water Pump Pulley With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Tighten the bolts diagonally when installing.
Remove the drive belt.
(Refer to Timing System - "DRIVE BELT ")
Fill with engine coolant.
Start engine and check for leaks.
Recheck engine coolant level.