Cooling Fan Assembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the battery terminals.
Remove the under cover. (Refer to Engine and Transaxle Assembly - "ENGINE ROOM UNDER COVER ")
Disconnect the air duct (A).

Fig 1: Locating Air Duct With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the cooling fan connector (A).

Fig 2: Locating Cooling Fan Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the vacuum hose (A).

Fig 3: Locating Vacuum Hose
Courtesy of HYUNDAI MOTOR AMERICA
Remove the front bumper cover. (Refer to Body - "FRONT BUMPER COVER ")
Remove the intake shield (A).
Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Fig 4: Locating Intake Shield With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting bolts and then remove the cooling fan (A).
Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Fig 5: Locating Cooling Fan With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.