Removal and Installation: Notes

WARNING: This page is about a different variant/trim than selected.

Remove the engine cover.
Disconnect the battery negative terminal.
Disconnect the air duct (A).

Fig 1: Locating Air Duct With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the air duct and air cleaner assembly.
Tightening torque

Hose clamp bolt:

2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)

Air cleaner assembly bolts:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
1. Disconnect the breather hose (A), RCV hose (B), booster vacuum hose (C) and air intake hose (D).
2. Remove the air cleaner assembly (E).
  
  Fig 2: Locating Breather Hose, RCV Hose, Booster Vacuum Hose, Air Intake Hose And Air Cleaner Assembly
  Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.