Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the drive belt.
(Refer to Timing System - "DRIVE BELT ")
Remove the A/C compressor lower mounting bolts (A).
Remove the A/C compressor bracket (B).

Fig 1: Removing A/C Compressor Lower Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Drain the engine oil.
(Refer to Lubrication System - "ENGINE OIL ")
Remove the oil pan (A). Insert the blade of SST (09215-3C000) between the ladder frame and oil pan. Cut off applied sealer and remove the lower oil pan.

Fig 2: Removing Oil Pan
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of (1) arrow.
- After tapping the SST with a plastic hammer along the direction of (2) arrow around more than 2/3 edge of the oil pan, remove it from the ladder frame.
- Do not turn over the SST abruptly without tapping. It be result in damage of the SST.