LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Lubrication System - 2.0L (Except HEV)) >> Balance Shaft & Oil Pump >> Repair Procedures >> Removal >> BSM (Balance Shaft Module) Chain System

BSM (Balance Shaft Module) Chain System

WARNING: This page is about a different variant/trim than selected.
  1. Remove the timing chain.

    (Refer to Timing System - "TIMING CHAIN ")

  2. Install a stopper pin (A) after compressing the balance shaft chain tensioner.
  3. Remove the balance shaft chain tensioner (B).
  4. Remove the balance shaft chain tensioner arm (C).
  5. Remove the balance shaft chain guide (D).
  6. Remove the balance shaft chain (E).
    Fig 1: BSM (Balance Shaft Module) Chain System Components
    G11994054Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the BSM (Balance Shaft Module) after removing the BSM mounting bolts.
    Fig 2: Removing BSM Mounting Bolts
    G11994055Courtesy of HYUNDAI MOTOR AMERICA
    NOTE: Do not disassemble the BSM (Balance Shaft Module).
scientia non olet · About LEMON Manuals