LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Fuel Delivery System - 1.6L (Except HEV)) >> Fuel Tank >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Remove the rear seat cushion. (Refer to Body - "REAR SEAT ASSEMBLY ")
  3. Remove the fuel pump service cover (A) in the trunk.
    Fig 1: Locating Fuel Pump Service Cover
    G11987350Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel feed tube quick-connector (A).
  5. Disconnect the fuel pressure sensor connector (B).
  6. Disconnect the fuel pump control module (C).
    Fig 2: Locating Fuel Feed Tube Quick-Connector, Fuel Pressure Sensor Connector And Fuel Pump Control Module
    G11987351Courtesy of HYUNDAI MOTOR AMERICA
  7. Lift the vehicle.
  8. Remove the main muffler.

    (Refer to Engine Mechanical System - "MUFFLER ")

  9. Support the fuel tank with a jack.
  10. Disconnect the fuel filler hose (A).
  11. Disconnect the vapor hose quick-connector (A).
    Fig 3: Locating Vapor Hose Quick-Connector
    G11987352Courtesy of HYUNDAI MOTOR AMERICA
  12. Disconnect the fuel tank pressure sensor extension connector (A).
    Fig 4: Locating Fuel Tank Pressure Sensor Extension Connector
    G11987353Courtesy of HYUNDAI MOTOR AMERICA
  13. Remove the fuel tank bands (A) installation nuts.
    Fig 5: Locating Fuel Tank Bands
    G11987354Courtesy of HYUNDAI MOTOR AMERICA
  14. Remove the fuel tank after removing the fuel tank band (A).
    Fig 6: Locating Fuel Tank Band
    G11987355Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals