LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Fuel Delivery System - 1.6L (Except HEV)) >> Fuel Pump >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Lift the vehicle.
  3. Support the fuel tank with a jack.
  4. Pull fuel tank in direction of a down by loosening the mounting nut (A) appropriately.
    Fig 1: Locating Fuel Tank Mounting Nuts
    G11987357Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the rear seat cushion. (Refer to Body - "REAR SEAT ASSEMBLY ")
  6. Remove the fuel pump service cover (A).
    Fig 2: Locating Fuel Pump Service Cover
    G11987358Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the fuel pump control module connector (A).
  8. Disconnect the fuel feed tube quick-connector (B).
  9. Disconnect the fuel pressure sensor connector (C).
    Fig 3: Locating Fuel Pump Control Module Connector, Fuel Feed Tube Quick-Connector And Fuel Pressure Sensor Connector
    G11987359Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the locking ring (A) by using the special service tool (B) [No.: 09310-B9100].
    Fig 4: Removing Locking Ring Using Special Service Tool
    G11987360Courtesy of HYUNDAI MOTOR AMERICA
  11. Remove the fuel pump from the fuel tank.
    Fig 5: Removing Fuel Pump From Fuel Tank
    G11987361Courtesy of HYUNDAI MOTOR AMERICA