LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Fuel Delivery System - 1.6L (Except HEV)) >> Filler-Neck Assembly >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Open the fuel filler door and then remove the filler-neck installation screw (A).
    Fig 1: Locating Filler-Neck Installation Screws
    G11987396Courtesy of HYUNDAI MOTOR AMERICA
  3. Lift the vehicle.
  4. Remove the rear-LH wheel, tire, and the inner wheel house.
  5. Remove the rear sub frame.

    (Refer to Suspension System - Rear Sub Frame - "Rear Cross Member ")

  6. Disconnect the canister close valve connector (A).
    Fig 2: Locating Canister Close Valve Connector
    G11987397Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the fuel filler hose (A).
  8. Disconnect the ventilation hose (B) from the fuel tank air filter.
    Fig 3: Locating Fuel Filler Hose And Ventilation Hose
    G11987398Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).
    Fig 4: Locating Bracket Installation Bolt
    G11987399Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals