Repair Procedures: Replacement

NOTE:

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

Fig 1: Locating Crash Pad Garnish Assembly (RH)
Courtesy of HYUNDAI MOTOR AMERICA
After loosen the mounting screws, remove the crash pad passenger side garnish (A).

Fig 2: Locating Crash Pad Passenger Side Garnish With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screw, then remove the crash pad garnish assembly [RH] (A).

Fig 3: Locating Crash Pad Garnish Assembly (RH) With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Replace any damage clips.