Repair Procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the center fascia lower panel assembly (A).

Fig 1: Locating Center Fascia Lower Panel Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the A/C & heater controller connectors (A).

Fig 2: Locating A/C & Heater Controller Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Lower the steering wheel.
Using a screwdriver or remover, remove the steering column shroud upper panel (A).

Fig 3: Locating Steering Column Shroud Upper Panel
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the cluster fascia upper panel assembly (A).

Fig 4: Locating Cluster Fascia Upper Panel Assembly
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screw, then remove the center fascia upper panel assembly (A).

Fig 5: Locating Center Fascia Upper Panel Assembly With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Replace any damage clips.