Repair Procedures: Replacement

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad side cover (A).

Fig 1: Locating Crash Pad Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the stopper (B) from the glove box (A).

Fig 2: Disconnecting Stopper From Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the air damper (A) from the glove box (B).

Fig 3: Locating Air Damper And Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the pin (A) and then remove the glove box (B).

Fig 4: Removing Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the passenger's under cover (A).

Fig 5: Removing Passenger's Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 6: Locating Connector
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the glove box housing (A).

Fig 7: Locating Glove Box Housing With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 8: Locating Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damaged clips.