LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Indicators & Gauges >> Instrument Cluster >> Repair Procedures >> Inspection >> Main Fuel Gauge Sender

Main Fuel Gauge Sender

  1. Using an Ohmmeter, measure the resistance between Terminals 1 and 3 of sender connector (A) at each Float level.
    Fig 1: Measuring Resistance Between Sender Connector Terminals
    G10605867Courtesy of HYUNDAI MOTOR AMERICA
  2. Also check that the resistance changes smoothly when the Float is moved from "E" to "F"
    Segment Position Resistance (Ω)
    12 Sender (F) 15 ± 2
    6 1/2 66.2 ± 2
    1 Warning Lamp 156 ± 2
    1 Sender (E) 200 ± 3
  3. If the height resistance is unsatisfied, replace the Fuel Sender as an assembly.
    CAUTION: After completing this test, wipe the Sender dry and reinstall it in the Fuel Tank.
scientia non olet · About LEMON Manuals