General Information (Body Interior And Exterior) (PHEV): Troubleshooting
Troubleshooting
| Symptom | Possible cause | Remedy |
|---|---|---|
| Water leaks from panorama sunroof | Dirt accumulated in drain tube | Clear dirt inside of drain |
| Clogged drain tube | Blow air into drain to remove dirt | |
| Broken or dislocated drain tube, defective or cracked clip | Check tube installation and flange contact | |
| Deteriorated roof lid weatherstrip | Replace | |
| Remove the work fitted. Should be improper weatherstrip installation. | Adjust | |
| Wind noise around panorama sunroof | Loose or deformed deflector, gaps in body work | Retighten adjust or replace |
| Misaligned weather strip | Readjust or replace weather strip | |
| Noise created by moving panorama sunroof lid | Foreign particles lodged in guide rail | Check drive cable and guide rails for foreign particles |
| Loosen guide rails and lid | Retighten | |
| Motor runs but panorama sunroof does not move or moves only partially | Foreign particles lodged in guide rail | Adjust or replace |
| Incorrect engagement of motor pinion with drive cable | ||
| Decrease in motor's clutch slipping force | ||
| Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc. due to mal adjustment of panorama sunroof | ||
| Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed is not an unusual noise | Incorrect engagement of motor pinion with drive cable | Check pinion installation and Re-tighten motor |
| Worn out or damaged motor pinion bearing | Replace motor assembly | |
| Worn out or deformed drive cable | Replace | |
| Door glass fails to operate up and down | Incorrect window glass installation | Adjust position |
| Damaged or faulty regulator arm or regulator | Correct or replace | |
| Door does not open or close completely | Incorrect door installation | Adjust position |
| Defective door check assembly | Correct or replace | |
| Striker and latch not properly aligned | Readjust | |
| Door hinge requires grease | Apply grease | |
| Hood does not open or close completely | Striker and latch not properly aligned | Adjust |
| Incorrectly installed hood | Adjust | |
| Incorrect hood bumper height | Adjust | |
| Water leak through windshield and rear window | Defective seal | Fill with sealant |
| Defective flange | Correct |