Repair procedures: Replacement

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad side cover (A).

Fig 1: Crash Pad Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the stopper (B) from the glove box (A).

Fig 2: Stopper And Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the air damper (A) from the glove box (B).

Fig 3: Air Damper And Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the pin (A) and then remove the glove box (B).

Fig 4: Pin And Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the passenger's under cover (A).

Fig 5: Passenger Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 6: Connector
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the glove box housing (A).

Fig 7: Glove Box Housing
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 8: Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damaged clips.