Repair procedures: Replacement

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad side cover (A).

Fig 1: Crash Pad Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the fuse box cover (A).

Fig 2: Fuse Box Cover
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the crash pad lower panel (A).

Fig 3: Crash Pad Lower Panel
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the diagnosis connector (A) and connector (B).

Fig 4: Diagnosis Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damaged clips.