Repair procedures: Replacement

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the center fascia side garnish (A).

Fig 1: Center Fascia Side Garnish
Courtesy of HYUNDAI MOTOR AMERICA
Remove the gear boots (B) and gear knob (A).

Fig 2: Gear Boots And Knob
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the console upper tray complete (A).

Fig 3: Console Upper Tray
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 4: Connectors
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the cup holder tray (A).

Fig 5: Cup Holder Tray
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the center fascia tray (A).

Fig 6: Center Fascia Tray
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 7: Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the center fascia panel (A).

Fig 8: Center Fascia Panel
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 9: Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.