Removal and Installation

Remove the Air Duct And Air Cleaner Assembly.
(Refer to: Intake and Exhaust System - "AIR CLEANER ").
Remove the Intercooler Outlet Hose (A).
Tightening Torque:

4.9 ~ 6.8N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)

Fig 1: Intercooler Outlet Hose
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Intercooler Inlet Hose & Pipe (A).
Tightening Torque

Bolt:

19.6 ~ 26.4N.m (2.0 ~ 2.7 kgf.m, 14.4 ~ 19.5 lb-ft)

Clamp:

4.9 ~ 6.8N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)

Fig 2: Intercooler Inlet Hose & Pipe (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Intercooler Inlet Hose & Pipe (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
NOTE:
- Match the marking part of the Hose and marking part of Throttle Body and Compressor.
- Match the Pipe Stopper and Hose Marking.
- When the Band Part have been place on the top of the Position Mark of the Hose, install to not exceed the mark.
- Tighten until the Torque Control Cap is released. If there is no the Torque Control Cap, tighten as Specified Torque.