Rear Pillar Trim Replacement

CAUTION:

Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to without marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the Rear Seat.
(Refer to: BD procedure - "REAR SEAT ").
Using a screwdriver or remover, remove the Rear Transverse Trim (A).

Fig 1: Rear Transverse Trim
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the Mounting Screw, remove the Rear Door Scuff Trim (A).

Fig 2: Rear Door Scuff Trim Mounting Screw
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the Mounting Bolt, remove the Rear Seat Belt Lower Anchor (A).
[LH, RH]

Tightening Torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

Fig 3: Rear Seat Belt Lower Anchor Mounting Bolt
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the Center Pillar Lower Trim (A).
[LH]

Fig 4: Center Pillar Lower Trim (LH)
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the Luggage Side Trim Lamp (A).
Disconnect the Luggage Side Trim Lamp Connector (B).
After loosening the Mounting Screws, remove the Luggage Side Trim (C).
[LH]

Fig 5: Removing Luggage Side Trim (LH) (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

[RH]

Fig 6: Removing Luggage Side Trim (RH) (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the Mounting Bolts, remove The Rear Pillar Trim (A).
[LH]

Fig 7: Rear Pillar Trim Mounting Bolts (LH)
Courtesy of HYUNDAI MOTOR AMERICA

[RH]

Fig 8: Rear Pillar Trim Mounting Bolts (RH)
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.

NOTE: