Glove Box Housing Replacement

CAUTION:

A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape and apply protective tape around the related parts to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the Crash Pad Side Cover (A).

Fig 1: Locating Crash Pad Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the Guide (B) from the Glove Box (A).

Fig 2: Glove Box Guide
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the Lift (A) from the Glove Box (B).

Fig 3: Glove Box Lift
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the Pin (A) and remove the Glove Box (B).

Fig 4: Glove Box Pin
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the Mounting Screws, remove the Glove Box Housing (A).

Fig 5: Glove Box Housing Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the Glove Box Lamp Connector (A).

Fig 6: Glove Box Lamp Connector
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damaged clips.