Repair Procedures: Replacement

Raise the vehicle, and make sure it is securely supported.
Remove the wheel cap (A).

Fig 1: Identifying Wheel Cap
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Be careful not to damage to the wheel cap (A) when removing the it.
Remove the front wheel and tire (A) from front hub.
Tightening Torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Fig 2: Locating Wheel Cap
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
Loosen the nut and then remove the rear stabilizer link (B) with the rear carrier.

Fig 3: Identifying Rear Stabilizer Link Nut
Courtesy of HYUNDAI MOTOR AMERICA

Tightening Torque:

78.5 ~ 98.1 N.m (8.0 ~ 10.0 kgf.m, 57.9 ~ 72.3 lb-ft)
Loosen the mounting bolt and then remove the stabilizer bar with the sub frame.
Tightening Torque:

44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

Fig 4: Loosening Stabilizer Bar Mounting Bolt

Courtesy of HYUNDAI MOTOR AMERICA

Fig 5: Identifying Stabilizer Bar

Courtesy of HYUNDAI MOTOR AMERICA