Main harness Circuit Inspection(1)
- Ignition "OFF".
- Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
- Disconnect Seat belt Buckle Switch connector and SRSCM main harness connector.
- Measure resistance between of the Buckle Sensor High Driver wiring connector and SRSCM harness connector.
Specification: approx. below 1Ω
- Is the measured resistance within specifications?
YES
- Go to "MAIN HARNESS CIRCUIT INSPECTION(2) " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation.
If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.