Component Inspection

Ignition "ON" & Engine "OFF" and Using a GDS, clear the DTC.
Ignition "OFF".
Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
Disconnect Seat belt Buckle Switch connector.
Substitute the Seat belt Buckle Switch and check for proper operation.
Is DTC present problem?
YES
- Substitute a known-good SRSCM, and check for proper operation.
  If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute a known-good Seat belt Buckle Switch, and check for proper operation.
  If the problem is corrected, replace Seat belt Buckle Switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.