Main harness Circuit Inspection

Ignition "OFF".
Disconnect the battery (-) terminal cable from the battery and wait at least one minutes.
Disconnect Passenger airbag active vent (3nd stage) connector and SRSCM main harness connector.
WARNING: Lay Removed PAB facing upward for unexpected air bag deploy.
Measure resistance between terminal "Low" and "High" of the Passenger airbag active vent (3nd stage) harness connector.
Specification: approx. below 1 Ω
Is the measured resistance within specifications?
YES
- Substitute a known-good SRSCM, and check for proper operation.
  If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation.
  If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.