Wiring Precautions
WARNING: This page is about a different variant/trim than selected.
SRS wiring can be identified by special yellow outer covering Observe the instructions described in this section.
- Never attempt to modify, splice, or repair SRS wiring. If there is an open or damage in SRS wiring, replace the harness.
- Be sure to install the harness wires so that they are not pinched, or interfere with other parts.
- Make sure all SRS ground locations are clean, and grounds are securely fastened for optimum metal-to-metal contact.
Poor grounding can cause intermittent problems that are difficult to diagnose.