Flange With Guide Pin
WARNING: This page is about a different variant/trim than selected.
Check the new O-ring for damage (use only the specified) and lubricate by using compressor oil. Tighten the nut to specified torque.
BOLT SIZE TORQUE SPECIFICATIONS
| Size | Tightening torque [N.m (kgf.m, lb-ft)] | |
|---|---|---|
| General bolt, nut | ||
| 4T | 7T | |
| M6 | 5 - 6 (0.5 - 0.6, 3.6 - 4.3) | 9 - 11 (0.9 - 1.1, 6.5 - 7.9) |
| M8 | 12 - 14 (1.2 - 1.4, 8.7 - 10) | 20 - 26 (2.0 - 2.6, 14 - 18) |
| M10 | 25 - 28 (2.5 - 2.8, 18 - 20) | 45 - 55 (4.5 - 5.5, 32 - 39) |
| Size | Flange bolt, nut | |
| 4T | 7T | |
| M6 | 5 - 7 (0.5 - 0.7, 3.6 - 5.0) | 8 - 12 (0.8 - 1.2, 5.8 - 8.6) |
| M8 | 10 - 15 (1.0 - 1.5, 7 - 10) | 19 - 28 (1.9 - 2.8, 14 - 20) |
| M10 | 21 - 31 (2.1 - 3.1, 15 - 22) | 39 - 60 (3.9 - 6.0, 28 - 43) |
NOTE:
T means tensile intensity, which is stamped on the head of the bolt.