LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 93 (Battery Management System Diagnosis (HEV)) >> DTC U1005: Lost Communication with Drive Motor Control Module (H-CAN) >> General Information >> DTC Detecting Condition

General Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.
Item Detecting Condition Possible Cause
DTC Strategy
  • Prevent control logic error caused by abnormal H-CAN Communication
  1. Poor Connector contact and quality
  2. Power line of H-CAN wiring is open/shorted
  3. Ground wiring of H-CAN is shorted
  4. The short between H-CAN LOW and CAN HIGH
  5. Input any noise to the wiring of H-CAN LOW or HIGH
  6. Faulty termination resistor
  7. The short/open between BMS and the wiring harness of MCU via H-CAN
  8. In the HPCU (MCU+HCU+LDC), MCU fault
  9. BMS ECU fault
Detecting Method
  • Satisfied with H-CAN MCU CAN Lost for more than 500 msec.
Enable Condition
  • in the IG ON status, 9V
  • Not detected for DTCs: U1001
Threshold Value
  • H-CAN MCU CAN data Lost
DTC Release Condition
  • C-CAN Recovery
Service Lamp ON Condition
  • In case of 2 time DC (Driving cycle: ST ON ~ IG OFF 2 time)
Service Lamp "OFF" Condition
  • In case of satisfying release condition
Safety Mode
  • Normal High voltage: Main relay ON
  • BMS available power: Power Directing
scientia non olet · About LEMON Manuals