LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 93 (Battery Management System Diagnosis (HEV)) >> DTC P1A6F: Airbag Deployment Signal Circuit High >> Verification Of Repair >> Verification of Vehicle Repair

Verification of Vehicle Repair

WARNING: This page is about a different variant/trim than selected.

After a repair, it is essential to verify that the fault has been corrected.

  1. Conform the power supply of BMS ECU is between 9V and 16V.
  2. Connect scantool and select "Diagnostic Trouble Codes (DTCs) " mode.
  3. Clear DTC using a GDS.
  4. Drive the vehicle within DTC Enable conditions in General information.
  5. After selecting "Diagnostic Trouble Codes (DTCs) " mode and check DTC is recorded again.
  6. Are any DTCs recorded?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System is performing to specification at this time.
scientia non olet · About LEMON Manuals