General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Prevent deterioration of battery caused by high temperature
- Prevent accident caused by high temperature of battery
|
- Faulty Hybrid battery pack
- Poor connection or open in harness or connector between battery module and BMS
- Faulty temperature sensor No. 4 (D)
- Open in temperature sensor No. 5 (E) circuit
- Power short in temperature sensor No. 5 (E) circuit
- Faulty Fan Module
- Faulty BMS ECU
|
| Detecting Method |
- Hybrid Battery Temperature Sensor 'E' detect as threshold value for more than 5 sec.
|
| Enable Condition |
- Ignition ON Auxiliary battery volts between 9V and 16V
|
| Threshold value |
- Hybrid Battery Temperature Sensor 'E' is lower than -45°C (-49°F)
|
| DTC Release Condition |
- Hybrid Battery Temperature Sensor 'E' is higher than -45°C (-49°F)
|
| Service Lamp ON Condition |
- In case of 2 time DC (Driving cycle: ST ON ~ IG OFF 2 time)
|
| Service Lamp "OFF" Condition |
- In case of satisfying release condition
|
| Safety Mode |
- Normal High voltage: Main relay ON
- BMS available POWER: Power Directing
|