General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- To prevent incorrect temperature information due to open or short in Ambient Temperature Sensor
- To prevent incorrect control due to incorrect ambient temperature information
|
- Faulty Hybrid battery pack
- Poor connection or open in harness or connector between battery module and BMS
- Faulty Hybrid Battery Air Temperature Sensor 'A'
- Ground short in Hybrid Battery Air Temperature Sensor 'A'
- Faulty BMS ECU
|
| Detecting Method |
- Hybrid Battery Pack Air Temperature Sensor 'A' detect as threshold value for more than 5 sec.
|
| Enable Condition |
- Ignition ON Auxiliary battery volts between 9V and 16V
|
| Threshold Value |
- Hybrid Battery Air Temperature Sensor 'A' is higher than 110°C (230°F)
|
| DTC Release Condition |
- Hybrid Battery Air Temperature Sensor 'A' is lower than 110°C (230°F)
|
| Service Lamp ON Condition |
- In case of 2 time DC (Driving cycle: ST ON ~ IG OFF 2 time)
|
| Service Lamp "OFF" Condition |
- In case of satisfying release condition
|
| Safety Mode |
- Normal High voltage: Main relay ON
- BMS available POWER: Power Directing
|