General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- To prevent incorrect temperature information due to open or short in Ambient Temperature Sensor
- To prevent incorrect control due to incorrect ambient temperature information
|
- Faulty Hybrid battery pack
- Poor connection or open in harness or connector between battery module and BMS
- Faulty Hybrid Battery Air Temperature Sensor 'A'
- Open in Hybrid Battery Air Temperature Sensor 'A' circuit
- Power short in Hybrid Battery Air Temperature Sensor 'A' circuit
- Ground short in Hybrid Battery Air Temperature Sensor 'A'
- Faulty BMS ECU
|
| Detecting Method |
- The temperature difference among 5 temperature sensors (Max temperature or Min temperature) is over 30°C (86°F) for more than 30min.
- Air Temperature Sensor and 5 temperature sensors is in normal
|
| Enable Condition |
- Ignition ON Auxiliary battery volts between 9V and 16V
- Not detected for DTCs: P0A9D, P0A9E, P0AC7, P0AC8, P0ACC, P0ACD, P0AEA, P0AEB, P0BC4, P0BC5
|
| Threshold Value |
- The temperature difference among 5 temperature sensors (Max temperature or Min temperature) is over 30°C (86°F)
|
| DTC Release Condition |
- The temperature difference among 5 temperature sensors (Max temperature or Min temperature) is under 5°C (41°F)
|
| Service Lamp ON Condition |
- In case of 2 time DC (Driving cycle: ST ON ~ IG OFF 2 time)
|
| Service Lamp "OFF" Condition |
- In case of satisfying release condition
|
| Safety Mode |
- Normal High voltage: Main relay ON
- BMS available POWER: Power Directing
|