General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Prevent deterioration of battery caused by high temperature
- Prevent accident caused by high temperature of Battery
|
- Faulty hybrid battery pack
- Poor connection or open in harness or connector between battery module and BMS
- Faulty temperature sensor No. 1 to 5
- Open in temperature sensor No. 1 to 5 harness
- Ground short in temperature sensor No. 1 ~ 5 harness
- Faulty Fan Module
- Faulty BMS ECU
|
| Detecting Method |
- Temperature is higher than threshold for more than 5 sec.
|
| Enable Condition |
- Ignition ON Auxiliary battery volts between 9V and 16V
|
| Threshold Value |
- Maximum battery temperature is higher than 70°C (158°F)
|
| DTC release Condition |
- Battery temperature is less than 50°C (122°F)
|
| Service Lamp ON Condition |
- In case of 1 time DC (Driving cycle: ST ON ~ IG OFF 1 time)
|
| Service Lamp "OFF" Condition |
- In case of satisfying release condition
|
| Safety Mode |
- Stop supplying high voltage (Stop HEV function): Keep main relay status OFF
- BMS available POWER: 0kW
|