Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
Clutch pressure sensor installation: 11 ~ 15 N.m (1.1 ~ 1.5 kgf.m, 8.0 ~ 11.1 lb-ft)

NOTE: When installing, apply the ATF oil to the O-ring (A).

Fig 1: Identifying Clutch Pressure Sensor O-Ring
Courtesy of HYUNDAI MOTOR AMERICA
Perform the clutch pressure sensor calibration (Refer to "CLUTCH PRESSURE SENSOR CALIBRATION ").