Visual/Physical Inspection
WARNING: This page is about a different variant/trim than selected.
■ Check Immobilizer Lamp Circuit
- Ignition "ON" & Engine "OFF".
- Check if Immobilizer Lamp operates properly.NOTE: Right after Ignition "ON", Immobilizer lamp lights up for 30 secs.
If lamp blinks 5 times after ignition "ON", a fault exists in immobilizer system. - Is the immobilizer lamp operating properly?
YES
- Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "COMPONENT INSPECTION " procedure.