Component Inspection

WARNING: This page is about a different variant/trim than selected.

Check transponder.
1. IGN "ON" & Engine "OFF".
2. Neutralize PCM and Register transponder key by scantool.
  NOTE: Pin code is required to Neutralize PCM and to Register transponder key
3. Are Neutralizing and Registering completed normally?
  YES
  - Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NO
  - Substitute with a known-good transponder and perform key teaching procedure with scanner.
    If the problem is corrected, replace transponder and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.