LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 89 (Front Axle Assembly (HEV)) >> Front Hub Knuckle >> Repair Procedures >> Disassembly

Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the snap ring (A).
    Fig 1: Identifying Snap Ring
    G10588905Courtesy of HYUNDAI MOTOR AMERICA
  2. Remove the hub assembly from the knuckle assembly.
    1. Install the front knuckle assembly (A) on press.
    2. Lay a suitable adapter (B) upon the hub assembly shaft.
    Fig 2: Removing Hub Assembly From Knuckle Assembly
    G10588906Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the hub bearing inner race from the hub assembly.
    1. Install a suitable tool (A) for removing the hub bearing inner race on the hub assembly.
    2. Lay the hub assembly and tool (A) upon a suitable adapter (B).
    3. Lay a suitable adapter (C) upon the hub assembly shaft.
    4. Remove the hub bearing inner race (D) from the hub assembly by using press.
    Fig 3: Removing Hub Bearing Inner Race From Hub Assembly
    G10588907Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the hub bearing outer race from the knuckle assembly.
    1. Lay the hub assembly (A) upon a suitable adapter (B).
    2. Lay a suitable adapter (C) upon the hub bearing outer race.
    3. Remove the hub bearing outer race from the knuckle assembly by using press.
    Fig 4: Removing Hub Bearing Outer Race From Hub Assembly
    G10588908Courtesy of HYUNDAI MOTOR AMERICA
  5. Replace hub bearing with a new one.
scientia non olet · About LEMON Manuals