Repair Procedures: Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn the ignition switch OFF.
- Disconnect the intake actuator connector.
- Verify that the actuator operates to the recirculation position when connecting 12V to terminal 3 and grounding terminal 7.
- Connect the intake actuator connector.
- Turn the ignition switch ON.
- Check the voltage between terminals 5 and 6.
Specification
Door position Voltage (5-6) Error detecting Fresh 0.3 ± 0.15V Low voltage: 0.1V or less Recirculation 4.7 ± 0.15V High voltage: 4.9V or more It will feedback the current position of the actuator to controls.
- If the intake actuator does not operate well, substitute with a known-good intake actuator and check for proper operation.
- Replace the intake actuator if it is proved that there is a problem with it.