Monitor Scantool Data

WARNING: This page is about a different variant/trim than selected.

Ignition ON (SSB LED "BLUE") & Vehicle "STOP".
Connect GDS and select "Data Analysis" mode.
Select "Current Data" mode and monitor "Immobilizer CAR" parameter.
Specification:

Fig 1: Screen Display - Test Condition Ignition Key ON
Courtesy of HYUNDAI MOTOR AMERICA
Check as follows if "Immobilizer CAR" value is displayed as "IMMO"
- Replace HPCU (HCU) equipped with Immobilizer and then, check system is functioning properly.
- Replace ECU equipped with Immobilizer and then, check system is functioning properly.
- Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.