Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the under cover (A).
Tightening torque: 7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

Fig 1: Identifying Front Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the Electric Oil Pump (EOP) connector (A).

Fig 2: Identifying Electric Oil Pump (EOP) Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the Electric Oil Pump (EOP) connector (A) and clips (B).

Fig 3: Identifying Electric Oil Pump (EOP) Connector And Clips
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Electric Oil Pump (EOP) (A).

Fig 4: Identifying Electric Oil Pump (EOP)
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
CAUTION:
- Replace the seal (A) and O-ring (B) before installing the EOP.
- Install the EOP after removing the dust, foreign material on the commissure of the EOP.
  
  Fig 5: Identifying Electric Oil Pump (EOP) Seal & O-Ring
  Courtesy of HYUNDAI MOTOR AMERICA
- After the installation, start the engine and then check if there are any leakage from the EOP.
- Check the ATF level after refilling the automatic transaxle with fluid. (Refer to "FLUID ")