Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Air cleaner assembly and air duct.
(Refer to "ENGINE INTAKE & EXHAUST SYSTEM - SONATA HEV article)
Remove the ATF Warmer hose (A).

Fig 1: Identifying ATF Warmer Hose
Courtesy of HYUNDAI MOTOR AMERICA
Remove the under cover (A).
Tightening torque: 7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

Fig 2: Identifying Front Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the mounting bolt (A) and hose (B).
Remove the ATF Warmer (C) after removing the nut (5 EA).
Tightening torque: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 3: Identifying ATF Warmer
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Adding automatic transaxle fluid. (Refer to "FLUID ".)