Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Installation is the reverse of removal.
NOTE: When installing, apply the ATF oil or White Vaseline to the O-ring (A) to prevent damage during installation.

Fig 1: Identifying Solenoid Valve O-Ring
Courtesy of HYUNDAI MOTOR AMERICA

After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
- Adding automatic transaxle fluid. (Refer to "FLUID ".)
- Bleed air from the hybrid motor cooling system using GDS.
  (Refer to "COOLANT ")