Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Set room side lever and T/M side lever to "N" position.
Remove the air cleaner assembly.
(Refer to "INTAKE MANIFOLD ".)
Remove the Hybrid Power control Unit (HPCU).
(Refer to "HPCU (HYBRID POWER CONTROL UNIT) ")
Remove the shift cable mounting nut (B).
Disconnect the inhibitor switch connector (A).

Fig 1: Identifying Inhibitor Switch Connector & Shift Cable Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the manual control lever (B) and the washer after removing a nut (A).

Fig 2: Identifying Manual Control Lever & Nut
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When installing, fix the manual control lever and the inhibitor switch with Ø5 mm (0.1969 in.) fixing jig.
And then tighten the inhibitor assembly mounting bolts.
Remove the inhibitor assembly (A) after removing the bolts (2 ea).
Tightening torque: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 3: Identifying Inhibitor Assembly
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When installing, tighten the inhibitor assembly mounting bolt lightly.