Monitor Scantool Data
WARNING: This page is about a different variant/trim than selected.
- Engine "ON".
- Warm-Up the Engine until temperature reaches up to normal condition at EV mode with Engine start status.
- Using scantool, check if there is an error in MCU system.
If there is an error in MCU system, first do a troubleshooting for those system and then check A.A.F system.
- Is the same DTC displayed again?
YES
- Go to WIRING HARNESS INSPECTION procedure.
NO
- Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.