General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- A.A.F operating voltage detection MIL Lamp
|
- Stuck the A.A.F
- Damaged or not installed the linkage
|
| Enable conditions |
|
| Threshold value |
- the voltage is detected Over 4.9V, after IGN ON, when motor is driven to the direction of low feed back voltage for maximum 5 secs.
- Failed when opening flap
- Failed when closing flap
|
| Diagnosis time |
- Within 5 secs after IGN ON
- For 5 secs (Failed to open flap)
- For 5 secs (Failed to close flap)
|
| DTC clear time |
- After the system recovers the normal status and then keeps 40 WUC (Warm Up Cycle) times, it is possible to delete the DTC.
|