General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Faulty AHB ECU
|
| Enable Conditions |
- If the valve relay is switched ON and corresponding solenoid driver ON, below condition last over 10times
- Valve (Current regulated channel): the Current of the solenoid < target current * 90%
- Valve (Current non-regulated channel): the Current of the solenoid < 300mA
|
| Fail Safe |
- EBD warning lamp and buzzer are activated.
- "Stop! Check Brake!" message is displayed on LCD.
|