General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Faulty Bleeding Process
- leakage on hydraulic pipe lines
- Faulty pressure sensor
|
| Enable Conditions |
- In case of Pressure sensor offset that calculated during driving is over 15bar
- ECU compare the deviation pressure signal [HPA, BCP, ESC MCP]. If the change of pressure signal is discordant, ECU detect failure
|
| Fail Safe |
- EBD warning lamp is activated and buzzer is not activated
- "Check Brake!" message is displayed on LCD
|